New OSD Task Sequence Not Displaying

Recently been testing an upgrade scenario from ConfigMgr 2012 SP2 to Current Branch 1702 and during the course of putting together the legacy environment I came across a strange issue I’d not seen before. Essentially it goes like this:

A new OSD task sequence is created (doesn’t matter whether it is MDT-infused or not) and is deployed to All Unknown Computers. In my case I was using boot media to reach the WinPE environment on my test VM but there were no task sequences displayed. Checking the smsts.log file in the WinPE environment, it suggests that no policies are found.

The first time this happened the task sequence eventually appeared after about an hour or so. The next day I created a new one and exactly the same thing happened, with just the old TS showing up. I then saw this thread and changed my new task sequence availability time back 1 day. Et voila, the task sequence appeared.

Hope this helps anyone else scratching their head…

Leave a Reply

Your email address will not be published. Required fields are marked *